BCT Validator Plus
Compression and Deformation Resistance Testing Machine produced by the compression of the samples (containers and packaging) between two parallel plates and with controlled movement from the PC until the break of the samples tested.
It also allows to perform constant compression tests on the samples during a programmed time.
Fatigue Cycle tests to carry out research on containers and packaging.
Standards
ASTM D2412, ASTM D2659-16, ASTM D4169, ASTM D4577, ASTM D642, ASTM D7030, DIN 11093-9, DIN 16495:2013-12, DIN 55440,
DIN 9969, EN 16495, EN 8113, EN 9969, ISO 11093-9, ISO 16495, ISO 8113, ISO 9969
- Force Range 30 KN (6,700 lbf)
- System Measure Force 3 Load Cells (to avoid lateral loading errors) 0.03% FSD
- DC Drive System – Trial Speed Variator
- Deformation Measurement Encoder, precision 0.25 mm (0.01 in.)
- Resolution in force: 2 N (0.50 lbf.) / Resolution of electronic capture 1 N
- Plate displacement resolution: 0.01 mm (0.0004 in.)
- Mobile plate speed resolution: 2 mm / min. (0.1 in./min.)
- Flatness of plates: Flat within 0.25 mm (0.01 in.)
- Parallelism of plates: Parallelism within ± 1 mm (± 0.04 in.) Per meter
- Features Safety: E-Stop – Overload Protection Software – Switches (Switches), upper and lower limit limiters – Power Supply Protection Limit – Load sense with automatic return
- Detection Fault communication with automatic stop
- Test Speeds 1 – 300 mm / min (0.04 – 12 in./min.)
- Return Speed Plate 300 mm / min. (12 in./min.)
- Force Data Display – Displacement – Speed - Load Ratio – Elapsed Time
- Guiding the mobile plate by means of guided columns
- The test equipment is mounted on 4 silent-blocks that prevent noise and vibrations
- RS-232 interface
- Force Measurement – Selectable Units: Newton’s – Kg & Pounds
- Extension Measurement (Deformation samples) Selectable Units: millimeters and inches
|
|
- Robust and precision grounding machine
- Force Range 30 KN (6,700 lbf)
- 3 Precision Load Cells
- Fixed upper plate and parallel to the lower one (TAPPI)
- With Oscillating System (ISO)
- Size of Compression Plates: 1000 x 1000 mm
- Maximum separation between compression plates: 1000 mm
- Force Reading in N – Kg and Lb
- Deformation reading in: mm / in.
- Automatic return to initial trial position
- RS-232 interface
- Compatible with all versions of the LYNX Integral Management System
|
Maggiori Informazioni |