Crush Tester CDM-5
Crush Tester of Corrugated Board and Paper Samples CDM-5
The Crush Tester is used to measure the compressive strength of paper samples (Liner & Medium) Corrugated Board
CMT - RCT - CCT - ECT - FCT - PAT
New generation of Crush Testert controlled by microprocessor. The suitable sample holder (ECT – RCT – CCT – PAT …) with the test piece is placed in the center of the bottom plate of the compresometer. The lower plate is mobile and the compression force is captured by a precision load cell, coupled to the upper plate.
The results of the tests are shown on the 15 ” Laptop PC . If series of tests are carried out with the same type of sample, statistical results, average value and standard deviation are obtained. During the tests the Compressometer works at a very low speed, but when finishing and resetting, the return of the mobile platform to its initial test position is at the maximum speed (125 mm / min).
The specimen compression test equipment meets the specifications of the standards:
ECT test: APPITA / AS 1301.444s, DIN EN ISO 3037, FEFCO 8, ISO 13821, SCAN P33, TAPPI T 811, TAPPI T 823, TAPPI T 838, TAPPI T 839
FCT test: APPITA / AS 1301.429s, DIN EN ISO 3035, FEFCO No.6, SCAN P32, TAPPI T 825
RCT test: APPITA / AS 1301.407s, ISO 12192, SCAN P34, TAPPI T 822
CMT test: APPITA / AS 1301.434s, ISO 7263, SCAN P27, TAPPI T809
CCT test: SCAN P42, TAPPI T 843, UNE ISO 16945
PAT test: APPITA / AS 1301.430s, FEFCO No. 11, TAPPI T 821
Standards
DIN 16945, DIN 3035, DIN 3037, DIN 54518, DIN 7263, EN 3035, EN 3037, EN 7263, FEFCO 11, FEFCO 6, FEFCO 8,
FEFCO C.M.T. Test, ISO 12192, ISO 13821, ISO 16945, ISO 3035, ISO 3037, ISO 7263, ISO 9895
|
Caratteristiche Tecniche:
|
|
| Maggiori Informazioni | |
